Satlink Ws-6906 Software Upgrade

If you don't need a new operating system but just want to find newer satellites (e.g., a new satellite launched recently), you might only need to update the .

turn off the power or disconnect the cable during the upgrade. Doing so can permanently damage the device. : The upgrade typically takes about satlink ws-6906 software upgrade

| Error Message | Cause | Solution | | :--- | :--- | :--- | | | Wrong COM port or drivers missing | Open Windows Device Manager. Find the "Ports (COM & LPT)" entry. Change the COM port to COM4 or lower. | | "Flash Erase Fail" | Write-protected NAND chip | You must use a different version of the flashing tool (try V3.2.8 instead of V4.0). | | Meter stuck on "LOADING..." | Corrupted channel file after upgrade | Remove the SD card. Perform a hard reset (remove battery for 1 minute). Reinstall via Method A only. | | "File Mismatch" | You downloaded firmware for V3.0 but have V2.0 hardware | Stop immediately. Find the correct firmware. Flashing the wrong version will permanently brick the unit. | If you don't need a new operating system